![]() On dry land use the ear muffs discussed in Chapter 15. We also tried running it in water tonight and yeah, when you give it throttle it just bogs and stalls. This is to confirm the engine is in fact getting water through the entire cooling loop and nothing is clogging it or keeping it from transferring from the muffs to the engine. Checking the oil Checking your marine inboard or sterndrive engine's oil is just like checking. 3 'Thanks plugs are a little fou 'Thanks plugs are a little fouled so were gonna try that first. ![]() Once the engine is running you should always confirm water is exiting out of the proper ports after it circulates through the engine. Confirm Water is Circulating Through the Engine If there is an unexpected kink or hole in the hose, water may not reach the unit and could cause damage if overheated. Remember to only start the engine once the water is verified at the outboard itself. Start the Boats EngineĪt this point, once the water is turned on and running to the outboard unit, the boat can be started. One way to run a boat engine out of water to check its functionality is to use Muffs. Below we’ve given a brief procedure on how to properly install a set of muffs on a boats outboard. A boat motor should never be run without water running through it to coll the engine. A boat motor should never be run without water running through it to coll the engine. Make sure to verify the water is going to the muffs before starting the engine, this can be verified as water will be leaking out around the muffs. This video shows you how to install muffs of the boat motor. Once water is going to the intake ports the boat can then be started. ISURE MARINE Universal Rectangular Outboard Motor Water Flusher Boat Ear Muff Engine Flusher for Marine Boat. Once the hose is installed and the muffs are firmly in the proper position, turn the water on to bring water through the hose to the outboard. The pictures below show a motor flusher properly in position and connected to a water hose. Note the muffs cover all of the water intake holes on both sides of the lower unit. Once positioned over the holes on each side, a water hose needs to be fastened to the side that has the threaded insert as seen below. Redneck Convent Dual Water Feed Boat Motor Flusher Rectangular Cup Muffs with Hose Fittings Flush Kit Marine Outboard Engine Flushing. ![]() When installing the muffs they will need to cover the intake holes on each side. This flusher fits most Johnson/Evinrude, Mercury, Yamaha, Chrysler, Force, Honda, Nissan, Suzuki, and Tohatsu. It’s important to note there are holes located on each side of the outboard housing. Fully Install the Muffs in the Proper Location ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |